High-altitude base plate, hanging board operation method
1. Hanging by a suspension bracket plate, large rope (diameter 16 mm, length depending on the height of the building), hanging panels and seat belts, safety slide lock form. Before use carefully check the validity of the various components function.
2. The two large rope (load rope and safety rope) were fixed in a safe and reliable and stand on the riveting point, after inspection and acceptance by the hand, went down from the roof, take all the rope angle, take the edge, take place with a rubber canopy bottom, to prevent friction. Large rope contact area with the building wall, to add rubber sling or safety mats.
3. Will be hanging board, slide lock safety rope connected with a major commitment.
4. Operators wear seatbelts, secure slide lock and the other through the root of a large rope (safety rope) connected.
5. The operator will cut other tools installed in the pocket with spare, and then down the stairs into the hanging plate, was suspended state. Then by the staff with the roof, such as the bucket and squeegee tool to send, by hanging in the crane operator panel.
6. Side down, side jobs until the job is completed a trip, a trip down to finish the job fell to the ground, remove the bucket, hanging panels, and then work on the roof to begin the second trip.
Wall height to ensure safe operation in case of quality assurance. |
